SURFACE PREPARATION:
All surfaces must be thoroughly cleaned prior to applying your vinyl graphics.  Wipe surface dry with a clean, dry, lint-free cloth.  Dirt and dust particles will cause vinyl lettering to bubble
TEMPERATURE REQUIREMENTS:
The temperature of the intended surface should be 45 degrees Fahrenheit or above for best results.
VINYL GRAPHICS WET INSTALLATION:
1. Prepare application fluid: 4 drops of dish detergent to 1 quart of water in a spray bottle. (Ivory detergent is best because it is free of perfumes and other additives)

2. Mark guidelines with masking tape in the area you wish to apply your graphics

3. With the graphics face down, squeegee backing to make sure the graphics stick to the transfer tape. Carefully peel the backing paper away from the graphics.

4.Spray down the area to receive the graphics with an ample amount of application fluid to prevent vinyl from sticking to the surface, as well as the sticky side of the graphics.

5. Lightly place the graphics on the prepared surface using your guidelines to position them correctly. Graphics may be removed and repositioned as long as surface stays wet. When happy with the position, firmly squeegee the graphics to force the bubbles and fluid out.  Start in the center and work your way out. Be sure you have squeegeed out all the application fluid before attempting to remove transfer tape.

6. Spray the transfer tape with the application fluid. Wait approx. 15 minutes. Gently peel the transfer tape away, keeping your hand firmly on the graphics to prevent pulling it back up.  Spray face of exposed graphics and carefully squeegee out any remaining bubbles and fluid. You may need to smooth it down one more time after leaving it dry for a couple of hours. Be careful not to scratch the vinyl. Use a piece of paper as a squeegee barrier if needed.

WASH WITH MILD SOAP AND WATER ONLY